Post #114089 by Octane on Sun, Sep 12, 2004 9:01 PM

it looks like you are trying to use the bits and drill down then trace out the pattern, instead use the tile cutter and start from the edge of the tile and cut into the tile then just cut over to your shape and cut it out. thats all the help i can add. This should stop it from slipping. I'm not sure the tile cutter is ment to drill through the tile and then cut, but i have never used the tile cutter on tile either.

[ Edited by: Octane on 2004-09-12 21:03 ]