suburbanpagan's new necklace carving - Tiki Carving

S suburbanpagan Member southern cal Joined: Jan 02, 2004 Posts: 826	S suburbanpagan Posted posted on Sun, Jun 19, 2005 12:19 PM Hey thanks! I like to use a two part silicon rubber for my molds and resin for the casts......I do like to use pulverized stone additives to give some of the simpler designs some heft but I think there is too much detail in this guy to use any additives because they tend to create too many air pockets....check out my site to see how some of the others turned out! :) http://www.thetackytiki.com/000_SPT_necklaces.html Also, go to http://www.micro-mark.com/ to check out the supplies! [ Edited by: suburbanpagan on 2005-06-19 14:48 ]

Hey thanks! I like to use a two part silicon rubber for my molds and resin for the casts......I do like to use pulverized stone additives to give some of the simpler designs some heft but I think there is too much detail in this guy to use any additives because they tend to create too many air pockets....check out my site to see how some of the others turned out! :)

http://www.thetackytiki.com/000_SPT_necklaces.html

Also, go to http://www.micro-mark.com/ to check out the supplies!

[ Edited by: suburbanpagan on 2005-06-19 14:48 ]

Post #166806 by suburbanpagan on Sun, Jun 19, 2005 12:19 PM