Cutting glass floats - Tiki Carving

D Digitiki Tiki Socialite L.A. baby! Joined: Jul 22, 2004 Posts: 818	D Digitiki Posted posted on Fri, Sep 23, 2005 12:03 PM If you are cutting the float in order to hang a puffer fish lamp in side, you will need to do way more than grind out a hole from a point (like you would a drill). You will need a diamond cutting wheel and cut a round section out. I doubtr that you could grind out a hole that big from the center of a small diamond bit. That would take way too long woudn't it? As far as netting, that seems to be the big snag for me. I don't know how in the world I'm going to get the net tied back the way it was before!!

If you are cutting the float in order to hang a puffer fish lamp in side, you will need to do way more than grind out a hole from a point (like you would a drill). You will need a diamond cutting wheel and cut a round section out. I doubtr that you could grind out a hole that big from the center of a small diamond bit. That would take way too long woudn't it?

As far as netting, that seems to be the big snag for me. I don't know how in the world I'm going to get the net tied back the way it was before!!

Post #188401 by Digitiki on Fri, Sep 23, 2005 12:03 PM