Post #269493 by Aaron's Akua on Wed, Nov 29, 2006 8:29 PM

All good advice, thanks guys. I was pretty sure that some of you weren't using the shield, but then again it goes against the grain to ignore the Mfr. warnings on these tools. I guess they're just going overkill on this one as a C.Y.A. & to limit their liability.

I mounted the disc today & was surprised at just how "un-sharp" it is. It sounds like they sharpen up pretty easy with a round 1/4" file, though.

Ben, good idea on the speed control. I will have to browse back a few pages here & add it to the Xmas list.

Thanks!