Post #601374 by newB24 on Sun, Aug 7, 2011 3:54 PM

Putting up the bamboo paneling was quite easy actually..

1 laid out where the holes were to be cut, just like hanging drywall
2 used a rotozip to cut out the holes
3. dialed down the pressure on my brad nailer to about 50 PSI
4. put the bamboo on the wall and just hit the brad nails through the knuckles, a few split but most of them just set flush and smooth.

You can't even see the joints where this stuff goes together and it lays perfectly smooth on the wall.

I'm either going to tackle the chair rail bamboo next or maybe I might put up the reed on the ceiling.

I need to figure out how to post a poll on here, I need to decide what to do with the window wells...

A. Paint them the same as the soffit
B. Put the Lauhala on there
C. Paint it a glowing orange
D. Any other ideas?

[ Edited by: newB24 2011-08-09 04:19 ]