Whystler's WIP Thread (cannibals printed and based) - Other Crafts

W Whystler Member Joined: Jul 07, 2012 Posts: 41	W Whystler Posted posted on Sun, Jul 8, 2012 11:35 AM Here are a couple of pictures of the 3d print before painting. This it the piece, cleaned, but in a raw abs plastic state. I have it ready to be coated with ivory matt spray paint. And here it is after the spray painting. You can see a lot more detail here. I'll paint this and see what it looks like. If it looks too rough after I'm done, I can change the layer printing setting. I printed this at .3mm layers. I can try and print it at .2mm as this is the finest for my printer. Otherwise, I may have to polish it before painting. -Whystler

Here are a couple of pictures of the 3d print before painting.

This it the piece, cleaned, but in a raw abs plastic state. I have it ready to be coated with ivory matt spray paint.

And here it is after the spray painting. You can see a lot more detail here.

I'll paint this and see what it looks like. If it looks too rough after I'm done, I can change the layer printing setting. I printed this at .3mm layers. I can try and print it at .2mm as this is the finest for my printer. Otherwise, I may have to polish it before painting.

-Whystler

Post #643210 by Whystler on Sun, Jul 8, 2012 11:35 AM