Post #643556 by Whystler on Tue, Jul 10, 2012 10:29 PM

On 2012-07-10 12:18, bavtech wrote:
What model of 3d printer are you using? Makerbot? Reprap?

This is something I have really been wanting to do for awhile. You can make so many things with a 3d printer.

I have heard that the DIY 3d printers tend to need a lot of maintenance to keep operational. What is your experience in setup and use?

THanks

Hey Bavtech - I use a printer called the "UP!" printer by pp3dp. The DIY printers do tend to need maintenance and tinkering. It's all part of the pioneer's road, I suspect. There is a lot to learn through trial and error for certain. What I like about the state of home printers at the moment, is that you can tinker a bit. It's like the old days ... your toaster broke down, you could fix it in your workshop by taking it apart and figuring it out. You might have to order a part to replace, but you could do it by undoing a few screws.

-Whystler