Whystler's WIP Thread (cannibals printed and based) - Other Crafts

W Whystler Member Joined: Jul 07, 2012 Posts: 41	W Whystler Posted posted on Thu, Jul 12, 2012 3:07 PM On 2012-07-11 20:08, Gene S Morgan wrote: Good detail. One question, is there a hole all the way through the center of the model? If that is true it could have a chord pass through it like an oversized bead. Just a thought. Oops! Sorry Gene, I didn't see your question until now. And thanks for your compliment! There is a hole through the centre of the model, and this was actually for the reason you mentioned. But then I found that the pendant didn't lie forward always against a person's chest since the piece is cylindical. One idea, that MadDogMike had, was to flatten the back, and I was going to take this suggestion at first. But then I realized if I put a horizantal hole through the sides, towards the top, and threaded the cord latterally, then the pendant would lay sitting forward always. So I did this instead. -Whystler [ Edited by: Whystler 2012-07-12 15:08 ]

On 2012-07-11 20:08, Gene S Morgan wrote:
Good detail. One question, is there a hole all the way through the center of the model? If that is true it could have a chord pass through it like an oversized bead. Just a thought.

Oops! Sorry Gene, I didn't see your question until now. And thanks for your compliment!

There is a hole through the centre of the model, and this was actually for the reason you mentioned. But then I found that the pendant didn't lie forward always against a person's chest since the piece is cylindical.

One idea, that MadDogMike had, was to flatten the back, and I was going to take this suggestion at first. But then I realized if I put a horizantal hole through the sides, towards the top, and threaded the cord latterally, then the pendant would lay sitting forward always. So I did this instead.

-Whystler

[ Edited by: Whystler 2012-07-12 15:08 ]

Post #643800 by Whystler on Thu, Jul 12, 2012 3:07 PM