Post #792183 by Donovan on Mon, Dec 31, 2018 4:54 PM

Funny you should mention working on the bar because that is what was on the schedule for today.
I wanted to use Jack Daniels barrel ends for liquor shelves.
This is the cutting of the barrel using a skill saw.

This is attaching the plywood backing. Be sure to glue and screw each individual board as it will shrink as it dries.

Leave about 6" of the end plate and glue it in place. Then mark where the rear shelf support will be level.

Then install some bracket supports for the clear shelf.

I used the plastic lens material for a fluorescent light to make the shelf. I used led under cabinet lights from Home Depot to illuminate each shelf and daisy chain wired them.




So far, so good.