Post #795836 by danlovestikis on Sun, Jun 23, 2019 10:01 AM

The making of the art for the July Tiki Art Swap by MadDogMike continues.

This is the product I used to do the Moai on the bisqueware fogcutter mug. I think it needs to go on a glazed surface.

It did not work on bisque. It fell off in the kiln.

The parts that stuck I removed or tried to remove with a pick.

Once I got off all that would come off I

re-glazed it with Black Pingo which is just a great glaze.

I did a second layer and

Then I let it dry.

All of a sudden glaze fell from the sky leaving a large defect here and

here.

So I used the pick to make sure nothing else was loose and then I re-glazed the sky.

Just before I put it in the kiln I decided to re-glaze the Birds Of Paradise. I let them dry then into the kiln.

A few days later when out of the kiln I rubbed the mug all over. The only defects were two tiny spots at the lip.

I got out the right colors and I painted these until they disappeared.

Even though I think it's fine to use and long as the edge isn't scrubbed or subjected to hot water, this mug could be called a painting.

24 hours later it went into the home oven to set the paint. I had jazzed up the flowers on this Tiki Bobette so in she went to. Hot Tub Hula Girl faces are always done in enamel. Sometimes I do an eyebrow 14 times before it looks good with the opposite one.

Here is the Finished Swap mug. I also did some more enamel clouds in the sky to blend the colors better.

I'm all done and ready to ship it to my Swap buddy. I hope no one else ran into to many problems. Cheers, Wendy

[ Edited by: danlovestikis 2019-06-23 10:03 ]