Post #311281 by benella on Wed, Jun 6, 2007 3:53 AM

Hi Duddy,

Thanks for the words.

For the swirls, I drew a line that showed the boarders of the future deep parts of the swirl.Then, I carved between the lines with the gouge I have on my carving jack (flexcut), trying to carve it in one move by curve (don't know if it is "understandable"), in order to avoid to have to sand too much.
At least, I sanded it with sand paper like any other piece by respecting the curves and not the lines of the wood.

Hope that will help you,

Benjamin.