Post #365974 by Bay Park Buzzy on Mon, Mar 10, 2008 2:51 PM

The finishing process went as follows:
Planed, sanded, ground, sanded, ground, sanded, burned, sanded, and stained.

After cutting every corner in the production process, I sprayed on some spar varnish.

I also had a log that wouldn't hold up to a good carve so I slaaped this horrid thing out.

I mostly did it to have an excuse to use the new mapp gas setup I bought. Burning was never so convenient!

Here's the rest of my Xmas tools I finally got:

A new sculptor's set with a new 1" 60 degree v tool. The thing on the bottom is quite handy for checking symetry and replicating shapes.

Almost updated!
Buzzy Out!