Bosko patio project- 07-07-10 update - Tiki Carving

T TikiTres Member Forney, TX Joined: May 28, 2008 Posts: 263	T TikiTres Posted posted on Wed, Jul 16, 2008 11:10 AM UPDATE 08-04-08- I've revised the title of this thread to more accurately reflect the random projects I'll be posting here. The "end goal" (if it ever ends) is a tiki-themed patio and pool area. Hey all, I searched and tried to find this specific info on these forums already, but didn't have much luck. I'm going to be making a wall sconce and plan on doing raised grain on it similar to a Witco piece. I'm not trying to duplicate the Witco look and probably couldn't even if I wanted to, but I am trying to get that raised grain appearance. I've been playing with some scrap poplar, the best results I've gotten so far were from burning with a torch and then hitting the wood with a cone shaped wire brush ("fine" version) chucked in a hand-held drill. It raises the grain pretty well, but the wire brush leaves behind a lot of scratches in the wood. I tried following this up with sandpaper, but due to the raised grain it's not possible to sand down between the grain and remove the scratches. I would appreciate any feedback from the many masters around here :) Thanks! [ Edited by: TikiTres 2008-10-13 13:18 ] [ Edited by: TikiTres 2010-07-07 13:19 ]

UPDATE 08-04-08- I've revised the title of this thread to more accurately reflect the random projects I'll be posting here. The "end goal" (if it ever ends) is a tiki-themed patio and pool area.

Hey all, I searched and tried to find this specific info on these forums already, but didn't have much luck. I'm going to be making a wall sconce and plan on doing raised grain on it similar to a Witco piece. I'm not trying to duplicate the Witco look and probably couldn't even if I wanted to, but I am trying to get that raised grain appearance. I've been playing with some scrap poplar, the best results I've gotten so far were from burning with a torch and then hitting the wood with a cone shaped wire brush ("fine" version) chucked in a hand-held drill. It raises the grain pretty well, but the wire brush leaves behind a lot of scratches in the wood. I tried following this up with sandpaper, but due to the raised grain it's not possible to sand down between the grain and remove the scratches. I would appreciate any feedback from the many masters around here :) Thanks!

[ Edited by: TikiTres 2008-10-13 13:18 ]

[ Edited by: TikiTres 2010-07-07 13:19 ]

Post #394439 by TikiTres on Wed, Jul 16, 2008 11:10 AM