Carved some New Guinea moldings - Tiki Carving

BPB Bay Park Buzzy Tiki Socialite West Bay Park, San Diego, CA Joined: Apr 07, 2006 Posts: 3066	BPB Bay Park Buzzy Posted posted on Tue, Apr 27, 2010 5:17 PM A little clean and symmetrical looking for PNG, but still pretty nice. :P Some questions I have about the time it takes for you to turn out these pieces: How long does your computer image generation cut'n paste/3d manipulation work part take? My only basis for comparison: Skinnydogs' showed us their hardware/software setup for jewelry and it took about 35-40 hours to render the original source image to 3d for the cutter setup. and then, How long does the cutter take to do those that you just did? And finally, What are the stock dimensions that your setup will accommodate: smallest piece possible top largest?(Will it do a 6' full round log, is what I'm really getting at...) Thanks, Buzzy Out!

A little clean and symmetrical looking for PNG, but still pretty nice. :P

Some questions I have about the time it takes for you to turn out these pieces:
How long does your computer image generation cut'n paste/3d manipulation work part take? My only basis for comparison: Skinnydogs' showed us their hardware/software setup for jewelry and it took about 35-40 hours to render the original source image to 3d for the cutter setup.

and then, How long does the cutter take to do those that you just did?

And finally,

What are the stock dimensions that your setup will accommodate: smallest piece possible top largest?(Will it do a 6' full round log, is what I'm really getting at...)

Thanks,
Buzzy Out!

Post #526556 by Bay Park Buzzy on Tue, Apr 27, 2010 5:17 PM