TD
Joined: Jun 24, 2002
Posts: 1916
|
TD
On 2010-04-27 17:17, Bay Park Buzzy wrote:
A little clean and symmetrical looking for PNG, but still pretty nice. :P
Some questions I have about the time it takes for you to turn out these pieces:
How long does your computer image generation cut'n paste/3d manipulation work part take? My only basis for comparison: Skinnydogs' showed us their hardware/software setup for jewelry and it took about 35-40 hours to render the original source image to 3d for the cutter setup.
and then, How long does the cutter take to do those that you just did?
And finally,
What are the stock dimensions that your setup will accommodate: smallest piece possible top largest?(Will it do a 6' full round log, is what I'm really getting at...)
Thanks,
Buzzy Out!
Yeah i'm interested too, these look great btw as does you tiki room .
[ Edited by: Tiki Diablo 2010-04-27 22:28 ]
|