Router Carving Day- October 13th 2012 - Vista, CA-UPDATED with Photos - California Events

M Monkeyman Tiki Socialite Vista, CA Joined: Mar 04, 2003 Posts: 2386	M Monkeyman Posted posted on Mon, Sep 10, 2012 7:26 AM It will be 3/4" pine shelving. You can make multiple depths but I would not get any deeper than 3/8" Its all about planning your design with your BITS in mind. As you draw each line on your work you need to think about which bit you will use to make that cut. When I am working with one router then I will make sure to make ALL the different cuts that require that bit. Then I move on to the next bit and do all of the cuts that require it. Otherwise you are constantly switching out bits and that wastes time.

It will be 3/4" pine shelving.

You can make multiple depths but I would not get any deeper than 3/8"

Its all about planning your design with your BITS in mind.
As you draw each line on your work you need to think about which bit you will use to make that cut.

When I am working with one router then I will make sure to make ALL the different cuts that require that bit.
Then I move on to the next bit and do all of the cuts that require it.

Otherwise you are constantly switching out bits and that wastes time.

Post #651444 by Monkeyman on Mon, Sep 10, 2012 7:26 AM