Post #67828 by Swanky on Mon, Jan 5, 2004 8:34 PM

I have pictures here somewhere...

Here is the hardware you are looking for. You should find this at Lowes or Home Depot, but you'll have to search. It'll be in the lamp parts area with harps and other things.

It has this notch near the edge. What you are doing is making a hole about 1 inch in diameter, and squeeze these prongs and stick the sucker in the fish and set it so the cut out in the prong gets fish in it to hang onto. Below I have used a piece of cardboard to demonstrate.

A puffer fish is VERY tough. I started by drilling a set of holes in the fish to act as a guide. I drilled more and more holes until I was close to making a hole. I thne used some heavy snips to cut around. I found I needed the hole to be bigger and it was tough going. These guys stink too. You have to be careful not to damage the quills as you do this, so try to be gentle.

Use a lot wattage bulb. That's all there is to it. The tough part is cutting the hole without damaging the fish. A big drill bit might do it, but I am not so sure. It would likely catch the first piece it hit and rip it all around. A jig saw would work if you had one.

Here is mine from the top. He's a big mutha, which made it a bit easier, but, maybe he's a bit thicker.

The Swank Pad Broadcast - If it's Swank...

[ Edited by: Swanky on 2004-01-05 20:36 ]