Tiki Central / Home Tiki Bars / The Cannibal Cove, Wolverhampton, UK
Post #761670 by AdOrAdam on Tue, Mar 29, 2016 2:40 PM
A
AdOrAdam
Posted
posted
on
Tue, Mar 29, 2016 2:40 PM
Thanks :) I would advise 2 people doing it. One person supports the rattan & sprays carpet adhesive, the other sticks the matting to the ceiling & uses an old paint roller to smooth it out. Spray the ceiling & the matting, wait the suggested time. Starting from the wall edges push & smooth inwards (it might 'bubble' so you just pull it off again when the adhesive is still not dry). Then use a old paint roller to push from the wall edges to the centre moving back & forth over the same spot several times. Here's a pic of a bit I actually did by myself, without trim: Where it hung down a little bit, I peeled it down, sprayed a little more adhesive under the edge & used the paint roller again - the trim also holds the edges up. I cut the rattan into manageable pieces before starting - nothing too large! I started off lower down the walls to get my eye in - I did figure, at worst, I'd have to scrap the bit I was using & try again but managed all the bits in one go. I look forward to your own thread! |