Bam Bam's carving thread - Tiki Carving

BB Bam Bam Tiki Socialite NEPA Joined: May 13, 2016 Posts: 506	BB Bam Bam Posted posted on Fri, May 20, 2016 4:02 PM Thanks, Skip! I had considered a bamboo root stem, but there really isn't any readily-available source around here - other than the internet, that is. I've decided to give the bowl the JB Weld treatment in the end. In the light of day there was heat damage visible that wasn't quite so obvious by porchlight. Evidently, despite being quite a hard wood, locust is quite happy to char relatively easily. I figure: A) There have been resin and high-temp plastic pipe bowls used since the 60's, and B) if you pack correctly and take your time you should never even have hot embers in contact with the walls of the bowl in the first place. cake build-up over time would serve to protect it even more.

Thanks, Skip! I had considered a bamboo root stem, but there really isn't any readily-available source around here - other than the internet, that is.

I've decided to give the bowl the JB Weld treatment in the end. In the light of day there was heat damage visible that wasn't quite so obvious by porchlight. Evidently, despite being quite a hard wood, locust is quite happy to char relatively easily. I figure: A) There have been resin and high-temp plastic pipe bowls used since the 60's, and B) if you pack correctly and take your time you should never even have hot embers in contact with the walls of the bowl in the first place. cake build-up over time would serve to protect it even more.

Post #764049 by Bam Bam on Fri, May 20, 2016 4:02 PM