Post #804447 by kala60 on Fri, Jul 8, 2022 6:41 PM

Good link. thanks. I have multiple things going against me with this poor. 2 layers of Plywood glue/screwed together should have been epoxied 2 years ago. delay cost me a bit a torque/twist of the top. Tough of use gravity when it's not level. Bamboo mat not level. I mis-calculated the sq inche reduction due to the cut out holes. Too much epoxy for this pour. I'll still use these on the lower work space countertop. Will be outside pool area. I doubt most will see the issues. It was a good first "training" run. The cooper claded Bar Tops should be easier. Fingers X'd.

This really is the easy part of the bar. Trying to level the bar ion a slooped pool deck. Tough.

Thanks for all comments.