Post #270765 by TreeTiki wahine on Wed, Dec 6, 2006 11:01 AM

Hey RodeoTiki

I am (probably) too heavy into documenting process in my design work. The TreeTikis & TableTikis are in this case laser fabricated, with minimal ~ very invisible welding. Even though this particular project is 'outside' tiki topic, it addresses your curiousity. Bless you for having more than 9 lives to sustain it.

Images of a studio project from drawing thru laser fab (actually the same machine that cut the tikis - a Mitsubishi LXP 40-30 nitrogen laser with O2 assist, Mitsu GeoTool software - 80kb buffer ~ for all you technically inquisitive) to finished details.

http://161.58.102.106/publichtm/ornamental_iron_com_galleryc_13.htm

thumbnails are clickable to check larger images out with some explanations. It can be a slow load, so enjoy patience.

ps - I have been thinking about a lamp - particularly a table lamp. ahh, but that is another week.

e-)
da TreeTiki wahine