Post #598854 by Beach Bum Scott on Fri, Jul 22, 2011 10:43 PM

It's been a while...
I've been messing around with clay modeling and resin casting...now I want to do some small scale wood stuff so
today I picked up one of the Flexcut carver starter kits and a few other tools then went to work on my first small wood piece.

I didn't break out the PBR till it was time to sand...
This sure is a lot harder than modeling clay.

Here I made a turtle from clay, poured a mold then cast it in resin.

When I cast the turtle I planned on carving someing on it but didn't know what, after looking at it for a while I realized the shell is perfect for a Kon Tiki.

After getting out the dremel and going to work, then pouring a new mold.

This is a panel piece I did last summer that I never posted.

The Moai are marching westward... FOM FOM FOM FOM

[ Edited by: Beach Bum Scott 2011-07-23 11:31 ]