McTiki Stuff - Tiki Carving

M McTiki Member Sunny Florida Joined: Aug 22, 2004 Posts: 1962	M McTiki Posted posted on Mon, Aug 13, 2012 4:29 PM Thank you guys! I tried to take a pic with the burr currently in use every 30 to 45 minutes. Its not easy to do a tutorial without a Go Pro or something and then narrate it...... It takes as much patience to carve a huge piece as it does for a panel. The difference is your. F^Up factor on a smaller piece. These burrs can dance at 22000 rpm! Whatever they touch...is affected. I have the "oh shit!" Pile to prove it. Oh...Will....the orange palm tree you mentioned was supposed to resemble a torch. You can't tell from the angles shown, but it is originating from the boat floor. Thank you all the same. Mahalo my friends McTiki [ Edited by: McTiki 2012-08-13 16:33 ]

Thank you guys!

I tried to take a pic with the burr currently in use every 30 to 45 minutes. Its not easy to do a tutorial without a Go Pro or something and then narrate it......

It takes as much patience to carve a huge piece as it does for a panel. The difference is your. F^Up factor on a smaller piece. These burrs can dance at 22000 rpm! Whatever they touch...is affected. I have the "oh shit!" Pile to prove it.

Oh...Will....the orange palm tree you mentioned was supposed to resemble a torch. You can't tell from the angles shown, but it is originating from the boat floor. Thank you all the same.

Mahalo my friends

McTiki

[ Edited by: McTiki 2012-08-13 16:33 ]

Post #648138 by McTiki on Mon, Aug 13, 2012 4:29 PM